VERITAS NetBackup 5330 Appliance Hardware Installation Manual page 42

Storage shelves and disk drives

Hide thumbs Also See for NetBackup 5330:

Table of Contents

Hardware installation procedures

Installing disk drives into a Primary Shelf or an Expansion Shelf

Starting with the bottom drawer (5), use your thumbs to pull out the two orange

latches towards the sides of the rack. Then, grasp the latches and pull out the

drawer until you can see all of the disk slots. Do not pull the drawer out further.

The front of each drawer identifies the disk drive slot numbering inside the

drawer. The numbering is the same in all drawers, as follows:

Take a disk drive from a box and remove its protective sleeve.

Pull up the disk latch and use it as a handle to install the disk into disk space

number 1 as follows:

Insert the disk straight down into the slot.

■

Align the two raised buttons on each side of the disk with matching gaps

■

in the slot.

Table of Contents