VERITAS NetBackup 5330 Appliance Hardware Installation Manual page 77

Configuring the IPMI from the NetBackup Appliance Shell Menu
4
At the Main_Menu prompt, type Support to navigate to the Support menu.
5
From the Main_Menu > Support view, enter the following command to
configure the remote management port:
IPMI Network Configure <IPAddress> <Netmask> <GatewayIPAddress>
where IP address is the new IP address of the remote management port. The
Subnet mask and Gateway enable connectivity between your network computer
and the remote management port.
The remote management port must be configured as a DHCP or static address.
At any point in time, you can run the following command to see the IPMI network
details:
IPMI Network Show
6
Enter the following command if you want to add a new user to access the IPMI
sub-system:
IPMI User Add <User_Name>
At the New Password prompt, enter a password for the user.
The default user name is sysadmin. The default password is P@ssw0rd,
where 0 is the number zero.
At any point in time, you can run the following command to view the users who
can access the IPMI:
IPMI User List
7
Type Return to return to the Main_Menu prompt.
8 Use a Cat5 cable to connect the IPMI port to the network.
9
The appliance is ready for initial configuration. See the NetBackup Appliance
Initial Configuration Guide for the appropriate platform for information about
initial configuration requirements and procedures.
See "About IPMI configuration" on page 19.
See "Configuring the IPMI from the NetBackup Appliance Shell Menu" on page 76.
See "Accessing and using the Remote Management interface" on page 78.
Hardware installation procedures 77