VERITAS NetBackup 5330 Appliance Hardware Installation Manual page 46

46 Hardware installation procedures
Installing the NetBackup 5330 compute node
8
Make sure that both rails are parallel and secure.
9
Fully extend both rails forward until the release buttons click.
10
Carefully lift the compute node and tilt the rear down towards the back of the
rails.
11
Locate the slots at the back of each rail.
12
Insert the two rear standoff pegs that extend from the side of the compute node
into the last rail slots.
13
Lower the front of the compute node into the rail slots at the front of the rail
extenders. A peg in the middle and a peg at the front of the compute node fit
into the rail slots.