To Adjust Service/Parking Brake - Tennant ATLV 4300 Service Manual

15. Reinstall the clevis pin and cotter pin into the
clevis on the rear of the new brake cable.
16. Reinstall the the tension spring onto the rear
brake assembly lever.
17. Check the foot pedal in the operators
compartment for proper adjustment. The
pedal should have less than 1" of free play.
Adjust the right pedal so it does not
contact the frame. Set the left pedal so
its surface is flush with the right pedal.
If the pedal needs to be adjusted----do so at
the front clevis. Tighten the large and small
jam nuts.
18. Reinstall any plastic ties that were removed.
19. Operate the machine and check the brakes
for proper operation.

TO ADJUST SERVICE/PARKING BRAKE

1. Open the hopper cover and tilt the hopper
back.
FOR SAFETY: Before Leaving Or
Servicing Machine; Stop On Level
Surface, Set Parking Brake, turn off
machine, and remove key.
2. Check the foot pedal in the operators
compartment for proper adjustment.
3. The pedal should have less than 1" of free
play.
NOTE: Adjust the right pedal so it does not
contact the frame. Set the left pedal so its surface
is flush with the right pedal.
4. If the pedal needs to be adjusted----do so at
the rear cable mount.
5. Loosen the jam nuts on the cable and adjust
until there is a slight pull on the cable.
Tighten the jam nuts. Repeat on both sides.
6. Close the hopper and cover.
7. Operate the machine and check the brakes
for proper operation.
ATLV 4300 330495 (10- -98)
CHASSIS
2-9