Tennant ATLV 4300 Service Manual page 201

9. Reconnect the battery cables to the starter
and the ground cables to the machine
frame.
10. Reinstall the radiator over flow tank into the
mount bracket.
11. Reinstall the hydraulic fluid filter and head
assembly onto the machine frame. Reinstall
the two hex screws and tighten to
18 -- 24 Nm (15 -- 20 ft lb).
12. Reinstall the fuel filter/water separator onto
the machine frame. Reinstall the two hex
screws and tighten to 8 -- 10 Nm (6 -- 8 ft lb)
13. Reconnect the fuel lines (rubber and steel)
14. Reconnect the exhaust pipe to the exhaust
manifold. Tighten the two hex screws to
37 -- 48 Nm (26 -- 34 ft lb).
15. Position the engine fan back on the upper
engine sheave. Install the four M6 hex
screws and tighten to 11 -- 14 Nm
(7 -- 10 ft lb).
16. Pivot the radiator back in position and install
the two upper hex screws into the "L"
brackets. Tighten to 8 -- 10 Nm (6 -- 8 ft lb)
17. Reinstall the four hex screws into the lower
radiator mount brackets. Tighten the screws
to 37 -- 48 Nm (26 -- 34 ft lb).
18. Reinstall the radiator hoses to the engine
and fill the cooling system with 4 L
(1 gal) of antifreeze.
19. Reconnect the over flow hose from the top
of the radiator to the over flow tank.
20. Reconnect the two engine oil lines leading
from the remote oil filter to the adaptor on
the front, right side of the engine.
NOTE: Make sure to mark the hoses for proper
re- -assembly! If the hoses are connected
incorrectly- -- -engine damage may result!
ATLV 4300 330495 (10- -98)
ENGINE- -DIESEL
6-15