CHASSIS
BRAKES AND TIRES
SERVICE BRAKES
The service brakes on the model ATLVt 4300 are
located on the rear wheels only. The service
brakes are mechanically actuated with two pedals
and two cables. The service brakes are
independent left to right.
There is a left and right brake pedal in the
operators compartment. These pedals can be
actuated together or just the right or just the left
pedal can be pressed.
TO REPLACE SERVICE BRAKE PADS
FOR SAFETY: Before Leaving Or
Servicing Machine; Stop On Level
Surface, Set Parking Brake, turn off
machine, and remove key.
1. Place blocks in front and back of the front
tires.
2. Jack up the rear of the machine at the
indicated jack points. Install jack stands
under the machine frame.
3. Make sure the parking brake is engaged.
Remove the five wheel nuts. Remove the
tire and wheel assembly from the machine.
4. Lift the hopper cover and tilt the hopper
back.
5. Disengage the parking brake.
2-6
ATLV 4300 330495 (10- -98)