Fuel Filter/Water Separator; To Replace Fuel Filter/Water Separator - Tennant ATLV 4300 Service Manual

FUEL FILTER/WATER SEPARATOR

The fuel filter/water separator cartridge filters
impurities from the diesel fuel. It is located on the
back side of the engine, to the right of the larger
hydraulic fluid filter.
Replace the fuel filter element every 200 hours of
operation.
NOTE: Check the fuel filter water trap daily for
water. Drain any water that has collected in the
cartridge.
TO REPLACE FUEL FILTER/WATER
SEPARATOR
FOR SAFETY: Before Leaving Or
Servicing Machine; Stop On Level
Surface, Set Parking Brake, And Turn
Off Machine.
1. Open the hopper cover and tilt the hopper
back.
2. Open the top engine cover.
3. Remove the five pan screws holding the rear
engine cover to the machine. Remove the
cover.
4. Locate the fuel filter/water separator in the
center of the upper machine frame. Remove
the air cleaner hose from the engine and air
cleaner. Place a drain pan under the filter.
5. Open the pet--cock on the bottom of the filter
cartridge. Let any water drain from the filter.
6. Un--screw the filter from the filter head.
Properly discard the old filter.
7. Place a small amount of oil on the rubber
O--ring on the new filter.
8. Screw the new filter onto the filter head.
Tighten until snug then 1/4 turn.
ATLV 4300 330495 (10- -98)
ENGINE- -DIESEL
6-7