Instrument Panel; To Remove Instrument Panel - Tennant ATLV 4300 Service Manual

ELECTRICAL

INSTRUMENT PANEL

The instrument panel on the model ATLVt 4300
is used to hold most of the electrical switches,
indicator lights, circuit breakers, and meters.

TO REMOVE INSTRUMENT PANEL

FOR SAFETY: Before Leaving Or
Servicing Machine; Stop On Level
Surface, Set Parking Brake, turn off
machine, and remove key.
1. Open the seat support and engage the prop
rod.
2. Locate the battery at the center of the
machine, on top and ahead of the front axle.
3. Remove the battery negative cable.
4. Disengage the prop rod and lower the seat
support.
5. Remove the cap from the center of the
steering wheel (snap out).
6. Remove the M20 hex nut from the center of
the steering wheel.
7. Use a puller to remove the steering wheel
from the steering column.
8. Remove the knob from the tilt steering wheel
pull lever.
9. If the machine is equipped with turn signals,
remove the turn signal unit from the steering
column.
10. Remove the two smaller pan screws from
the top side of the instrument panel.
11. Remove the two larger pan screws from the
back side of the instrument panel.
12. Carefully pull the instrument panel up until
the rubber boot clears the steering column.
13. Place the instrument panel back, against the
kick panel of the operators compartment.
14. The components located on the instrument
panel can now be serviced.
4-6
ATLV 4300 330495 (10- -98)