To Replace Battery - Tennant ATLV 4300 Service Manual

TO REPLACE BATTERY

FOR SAFETY: Before Leaving Or
Servicing Machine; Stop On Level
Surface, Set Parking Brake, turn off
machine, and remove key.
1. Open the seat support and engage the prop
rod.
2. Locate the battery at the center of the
machine, on top and ahead of the front axle.
3. Unhook and remove the rubber battery hold
down strap or remove the threaded hold
down bracket.
4. Remove the battery negative and positive
cables.
5. Lift the battery out of the machine.
6. Install the new battery in the machine in the
same orientation as the old one.
7. Reconnect the battery cables to the battery
(red cable to positive post, black cable to
negative post)
8. Reinstall the rubber battery hold down strap
or reinstall the threaded hold down bracket.
9. Disengage the prop rod and lower the seat
support.
10. Check the new battery for proper operation.
If battery needs charging, see TO CHARGE
BATTERY instructions in this section.
ATLV 4300 330495 (10- -98)
ELECTRICAL
4-5