13. Using a pry bar, pull the alternator away
from the engine until the belts are tight.
Proper belt tension is 10 mm (0.40 in) from
a force of 4 to 5 kg (8 to 10 lb) applied at the
mid-point of the longest span. Check and
adjust the belt tension every 100 hours of
operation. Hand tighten the top hex bolt
tight.
WARNING: Moving Belt And Fan Blades.
Keep Away.
14. Firmly tighten the lower hex bolt.
15. Reconnect the electrical wires to the back of
the alternator. See schematic in this section.
16. Reconnect the battery cables to the battery.
17. Close the engine cover and lower the seat
assembly.
18. Start the engine and check the alternator for
proper operation.
ATLV 4300 330495 (10- -98)
ELECTRICAL
4-15