P.O. Box 6 5400 AA Uden- -The Netherlands europe@tennantco.com www.tennantco.com Specifications and parts are subject to change without notice. Copyright E2005, 2007 Tennant Company. All rights reserved. EC DECLARATION OF CONFORMITY FOR MACHINERY (Directive 98//37/EEC, Annex II, sub A) Model: 1610 nr.: M16105003 TENNANT N.V.
Avoid contact with battery acid. Scrub Head Lift Area. Use manufacturer supplied or approved replacement parts. All repairs must be performed by a qualified service person. Do not modify the machine from its original design. Tennant 1610 (10- -05) Home Find... Go To..
Hazard. Do Not Use Flammable Stay Away Of Scrub Head Lift Area. Liquids Or Operate Machine In Or Near Flammable Liquids, Vapors Or Combustible Dusts. Do Not Pick Up Flammable Materials Or Reactive Metals. Tennant 1610 (04- -07) Home Find... Go To..
175AH/5H Traction Batteries Maximum battery dimensions: 181 mm W x 260 mm L x 292 mm H. 1. Park the machine on a level surface, remove the key and set the parking brake. Tennant 1610 (10- -05) Home Find... Go To..
Again, hot rinse water is sprayed on the soiled rollers allowing the two vacuum shoes to easily extract the soil from the rollers. Spray Nozzles Vacuum Shoe Vacuum Shoe Roller #1 Roller #2 Tennant 1610 (10- -05) Home Find... Go To..
READYSPACE tube as shown. VACUUM SHOE SOLUTION FLUSH LINE (2) 6mm SOCKET HEAD CAP SCREWS Step 5: Connect the solution flush line to the vacuum shoe (See DETAIL). Repeat for opposite side. Tennant 1610 (10- -05) Home Find... Go To..
Make sure that the shoe is positioned behind the VACUUM two support tabs. Use the screws removed from SHOE Step 4. Connect the vacuum hose to the extractor vacuum shoe as shown. SUPPORT TABS (2) Tennant 1610 (10- -05) Home Find... Go To..
ADJUSTING CONTROL CONSOLE HEIGHT Pull the console height adjustment lever and lift or lower the console to a comfortable operating height. Release lever to lock the position (Figure 4). FIG. 5 FIG. 4 Tennant 1610 (10- -05) Home Find... Go To..
(Figure 9). ReadySpace Cleaning: 30m (100 ft.) per minute. Restorative Extraction Cleaning: 15m (50 ft.) per minute. NOTE: The control grips activate the drive, brushes and solution flow. Tennant 1610 (10- -05) Home Find... Go To..
11° while transporting. 1. Park the machine on a level surface and turn the key to the off position. FOR SAFETY: When using machine, go slow on inclines and slippery surfaces. Tennant 1610 (10- -05) Home Find... Go To..
ReadySpace Cleaning. 5. After cleaning, relieve the water pressure from the accessory tool before disconnecting the solution hose. Squeeze trigger for five seconds after turning the key off. FIG. 17 Tennant 1610 (10- -05) Home Find... Go To..
3. Rinse out the recovery tank and the float shut-off screen with clean water (Figure 23). FIG. 21 FIG. 23 4. Replace the drain hose caps securely after draining. Tennant 1610 (10- -05) Home Find... Go To..
The electrolyte level (A) should slightly cover the battery plates (B). Add distilled water as needed. DO NOT OVERFILL, the fluid may expand and overflow while charging. Replace cell caps before charging (Figure 24). FIG. 26 FIG. 24 Tennant 1610 (04- -07) Home Find... Go To..
NOTE: To prolong the battery life, ONLY recharge the batteries after a total of 30 minutes of use or more. FIG. 28 3. Drain and rinse out the solution tank. FIG. 31 Tennant 1610 (10- -05) Home Find... Go To..
4. Remove any entangled carpet fibers and debris Restorative Extraction from the brushes (Figure 35). Replace brushes if Spray Tips (2) worn. To determine when to replace worn brushes observe the brush pressure meter. FIG. 37 Tennant 1610 (10- -05) Home Find... Go To..
Push retainer tab to the bottle. Do not use pointed objects to clean tips, release spray tip. damage will occur. FLUSH LINE (2) FIG. 41 5. Maintain the batteries (See BATTERY MAINTENANCE). Tennant 1610 (10- -05) Home Find... Go To..
0.004, 4 points, for each 6_C above or below 27_C. FOR SAFETY: When servicing machine, all repairs 2. Always follow proper charging instructions must be performed by a qualified service person. (See CHARGING BATTERIES). Tennant 1610 (10- -05) Home Find... Go To..
5. Check for loose or worn cables. Replace if worn. FIG. 48 FOR SAFETY: When servicing machine, jack machine up at designated locations only. Block machine up with jack stands. Tennant 1610 (10- -05) Home Find... Go To..
See example below: on/off truck or trailer, use tie- -down straps to secure machine to truck or trailer. NOTE: When transporting machine in freezing temperatures see STORING MACHINE. Tennant 1610 (10- -05) Home Find... Go To..
Spray tip pattern out of alignment. Realign spray tips. Plugged solution tank filter. Clean solution tank filter. Clogged solution line. Flush plumbing system. Faulty pump or solenoid. Contact Service Center. Low solution spray pressure. Prime solution system. Tennant 1610 (10- -05) Home Find... Go To..
Page 25
Loose or broken front brush motor belt. Contact Service Center. Short run time. Low battery charge. Charge batteries. Defective batteries. Replace batteries. Batteries need maintenance. See BATTERY MAINTENANCE. Faulty charger. Repair or replace battery charger. Tennant 1610 (10- -05) Home Find... Go To..
72 dB (1m x 1m) DECIBEL RATING AT OPERATOR’S EAR, 72 dB(A) INDOORS. VIBRATIONS AT HAND CONTROLS <1.0m/s MAXIMUM GRADE LEVEL 19% (11°) Transporting / 5% (3°) Cleaning Specifications are subject to change without notice. Tennant 1610 (10- -05) Home Find... Go To..