To Replace Engine Starter - Tennant ATLV 4300 Service Manual

ELECTRICAL

TO REPLACE ENGINE STARTER

FOR SAFETY: Before Leaving Or
Servicing Machine; Stop On Level
Surface, Set Parking Brake, Turn Off
Machine And Remove Key.
1. Tilt the seat assembly forward and engage
the prop rod. Disconnect the battery cables
from the battery.
2. Open the top engine cover.
3. Disconnect the wires from the starter motor.
4. Remove the two hex screws holding the
exhaust pipe to the exhaust manifold. Pull
the pipe out of the way for clearance to
remove the starter.
5. Remove the two hex nuts holding the starter
to the engine. Remove the starter from the
flywheel housing and out of the machine.
6. Position the new starter back in the flywheel
housing. Re--use the two hex nuts and
tighten to 18 -- 24 Nm (15 -- 20 ft lb).
7. Reconnect the electrical wires to the starter.
See schematic in this section.
8. Reinstall the exhaust pipe to the exhaust
manifold. Reinstall the two hex screws and
tighten to 18 -- 24 Nm (15 -- 20 ft lb).
9. Reconnect the battery cables to the battery
and check the starter for proper operation.
10. Close the engine cover and pivot the seat
assembly down.
4-16
ATLV 4300 330495 (10- -98)