To Replace Rear Tire And Wheel - Tennant ATLV 4300 Service Manual

7. Go back and finish tightening the four wheel
nuts to 122 -- 162 Nm (90 -- 120 ft. lb).
8. Check the new tires for wear and rotate
every 200 hours of operation.
9. Check the tire pressure every 50 hours of
operation.

TO REPLACE REAR TIRE AND WHEEL

FOR SAFETY: Before Leaving Or
Servicing Machine; Stop On Level
Surface, Set Parking Brake, turn off
machine, and remove key.
1. Place blocks in front and back of the front
tires.
2. Jack up the rear of the machine at the
indicated jack points. Install jack stands
under the machine frame.
3. Make sure the parking brake is engaged.
Remove the five wheel nuts. Remove the
tire and wheel assembly from the machine.
4. Position the new tire and wheel assembly
onto the front axle hub.
5. Reinstall the five wheel nuts and tighten to
122 -- 162 Nm (90 -- 120 ft. lb).
6. Remove the jack stands and lower the
machine to the floor.
7. Remove the blocks from the front tires.
8. Check the new tires for wear and rotate
every 200 hours of operation.
9. Check the tire pressure every 50 hours of
operation.
ATLV 4300 330495 (10- -98)
CHASSIS
2-11