Steering; To Set Turning Radius Stops - Tennant ATLV 4300 Service Manual

STEERING

The steering system on the ATLVt 4300 consists
of a hydraulic steering wheel motor and a dual
action hydraulic cylinder on the front axle. Service
instructions for these components can be found in
the HYDRAULIC section of this manual.

TO SET TURNING RADIUS STOPS

FOR SAFETY: Before Leaving Or
Servicing Machine; Stop On Level
Surface, Set Parking Brake, turn off
machine, and remove key.
1. Jack up the front of the machine at the
indicated jack points. Install jack stands
under the machine frame.
2. Turn the steering wheel all the way in one
direction.
3. Go under the machine and locate the
steering stop bolts on each end of the axle
assembly on the back side.
4. The wheel axle casting should NOT BE
touching the stop bolt. There should be
.030" clearance between the head of the
stop bolt and the edge of the wheel axle
casting.
5. If an adjustment needs to be made, loosen
the jam nut on the stop bolt and turn in or
out. Hold the bolt from turning and
re--tighten the jam nut.
6. Turn the steering wheel all the way the other
direction and repeat steps 4 and 5.
7. Remove the jack stands and lower the
machine.
ATLV 4300 330495 (10- -98)
CHASSIS
2-13