To Replace Circuit Breaker - Tennant ATLV 4300 Service Manual

TO REPLACE CIRCUIT BREAKER

FOR SAFETY: Before Leaving Or
Servicing Machine; Stop On Level
Surface, Set Parking Brake, turn off
machine, and remove key.
1. Open the seat support and engage the prop
rod.
2. Locate the battery at the center of the
machine, on top and ahead of the front axle.
3. Remove the battery negative cable.
4. Disengage the prop rod and lower the seat
support.
5. Remove the instrument panel. See TO
REMOVE INSTRUMENT PANEL
instructions in this section.
6. Locate the circuit breaker that needs to be
changed.
7. Mark and disconnect the wires leading to the
back of the circuit breaker.
8. Remove the metal retainer ring from the
back of the circuit breaker.
9. Push the circuit breaker out of the hole.
Retain the clear, rubber boot and discard the
circuit breaker.
10. Position the new circuit breaker into the
mount hole.
NOTE: The mount hole has a "D" shape to match
the shape of the circuit breaker.
11. Install the metal retainer ring onto the back
of the new circuit breaker. Push the retainer
all the way down the circuit breaker.
ATLV 4300 330495 (10- -98)
ELECTRICAL
4-9