Tennant ATLV 4300 Service Manual page 59

25. Reinstall the vacuum head adjustment knob.
26. Go under the machine and remove one
large jam nut from the lower end of the new
lift cable.
27. Position the new lift cable through the mount
hole in the actuator mount bracket. Reinstall
the large jam nut. Leave loose for now.
28. Install one small cable nut and washer on
the lower end of the cable.
29. Position the long, black cable lift nut through
the hole in the actuator lift block.
30. Thread the long, black lift nut onto the new
cable. Leave loose for now.
31. Install the cable clamp on the new cable and
into the machine frame. Reinstall the hex
screw and nut. Tighten to 18 -- 24 Nm
(15 -- 20 ft. lb).
32. See TO ADJUST VACUUM HEAD
ACTUATOR LIFT CABLE instructions in this
section.
33. Go back and tighten all jam nuts.
34. Raise the vacuum head and remove the
wood block.
35. Operate the machine and check the vacuum
head lift actuator for proper operation.
ATLV 4300 330495 (10- -98)
VACUUMING
3-11