Tennant ATLV 4300 Service Manual page 144

Model 70160
Introduction
Table of Contents
Introduction ......................................................................................................... 2
Identification ........................................................................................................ 3
Tools Required .................................................................................................... 3
Parts Drawing ...................................................................................................... 4 - 5
Parts List ............................................................................................................. 6 - 7
Repair information
Disassembly .................................................................................................. 8 - 10
Reassembly ................................................................................................... 11 - 12
Fault - Logic Troubleshooting .............................................................................. 13 - 17
Start-up Procedure .............................................................................................. 18
Introduction
This manual provides service information for Eaton Models 70160 variable displacement piston pumps. Step
by step instructions for the complete disassembly, inspection, and reassembly of the pump are given. The
following recommendations should be followed to insure successful repairs.
Remove the pump from the application.
Cleanliness is extremely important.
Clean the port areas thoroughly before disconnecting the hydraulic lines.
Plug the pump ports and cover the open hydraulic lines immediately after they're disconnected.
Drain the oil and clean the exterior of the pump before making repairs.
Wash all metal parts in clean solvent.
Use compressed air to dry the parts. Do not wipe them dry with paper towels or cloth.
Compressed air should be filtered and moisture free.
Always use new seals when reassembling hydraulic pumps.
Lubricate the new rubber seals with a petroleum jelly (Vaseline
Torque all bolts over gasketed joints, then repeat the torquing sequence to makeup for gasket
compression.
Verifying the accuracy of pump repairs on an authorized test stand is essential.
® ) before installation.
2