Tennant ATLV 4300 Service Manual page 35

9. Remove the M12 hex screw and washer
holding each stabilizer bar to the machine
frame.
10. Remove the M8 hex screw and nyloc nut
holding the leaf spring pivot pin into the
frame. Carefully push the pivot pin toward
the front of the machine.
NOTE: Make sure the front axle is supported in
some manner.
11. Remove the two nyloc nuts holding the rear
facing shackle plate to the left side of the
leaf spring. Pull the shackle plate off the two
hex screws. Pull the front shackle plate and
two screws out the front of the spring and
axle.
12. Lift the end of the leaf spring that is
disconnected from the axle. Move the axle
assembly down and over slowly so the two
brake cables and propel cable can be
slipped off the end of the axle.
13. Carefully drop the front axle assembly down
and out of the machine.
ATLV 4300 330495 (10- -98)
CHASSIS
2-15