Tennant ATLV 4300 Service Manual page 114

HYDRAULICS
17. Remove the five hydraulic fittings from the
motor and install in the new steering wheel
motor.
18. Install the new steering wheel motor
assembly in the machine in the same
orientation as the old one.
19. Reinstall the four M6 hex screws and tighten
to 8 -- 10 Nm (6 -- 8 ft. lb).
20. Push the motor and column back up in
position. Tighten the locking collars to
8 -- 10 Nm (6 -- 8 ft. lb).
21. Connect the five hydraulic hoses to the new
steering wheel motor. See hose diagram in
this section.
22. Position the instrument panel and rubber
boot over the top of the steering column.
NOTE: Be careful not to tear the boot.
23. Push the panel down until the four mount
holes line up with the weldnuts.
24. Reinstall the two small pan screws on top of
the panel and the two larger pan screws on
the back side of the panel. Hand tighten
tight.
25. Reinstall the tilt steering rod knob. Turn the
knob down tight.
26. Reinstall the steering wheel and M20 nut.
Tighten tight.
27. Reinstall the cap in the center of the steering
wheel (snap in).
28. Reinstall the turn signal assembly if the
machine is equipped with road light option.
29. Open the seat support and engage the prop
rod.
30. Reconnect the battery cable to the battery
(red cable to positive post, black cable to
negative post).
31. Disengage the prop rod and lower the seat
support.
32. Start the machine and check for proper
operation.
NOTE: Observe hydraulic cleanliness
requirements when opening hydraulic lines.
5-16 ATLV 4300 330495 (10- -98)