Tennant ATLV 4300 Service Manual page 37

10. Reconnect the two hydraulic hoses to the
steering cylinder.
NOTE: Observe hydraulic cleanliness
requirements when opening hydraulic lines.
11. Position the front tire and wheel assemblies
onto the front axle.
12. Reinstall the eight wheel nuts and tighten
finger tight.
13. Remove the jack stands and lower the
machine to the floor.
14. Go back and finish tightening the wheel nuts
to 122 -- 162 Nm (90 -- 120 ft. lb).
15. Reconnect the vacuum head to the front
axle.
16. Operate the machine and check for proper
operation.
ATLV 4300 330495 (12- -01)
CHASSIS
2-17