Tennant ATLV 4300 Service Manual page 45

10. Spin the large jam nut down until it bottoms
out on the cable housing. Spin the new
hydroback down until there is .50 inch of
threads between the large jam nut and the
end of the hydroback.
11. Install the one small cable nut on the other
side of the hydroback and lock it down.
Install the safety clip, rubber washer, and
the second cable nut. Lock the second nut
against the safety clip and the first cable nut.
Spin the clevis down against the second
cable nut. Lock the clevis to the nut.
12. Position the new hydroback into the mount
bracket. on the back side of the propel
pump. Tighten the jam nut. Make sure the
internal lock washer is on the hydroback
side of the mount bracket.
13. Install the hex screw and two spacers in the
clevis end of the cable and into the propel
pump arm. Tighten to 8 -- 10 Nm
(6 -- 8 ft. lb). Reinstall a plastic tie.
14. The neutral centering will have to be set at
this point. See TO ADJUST PROPEL
NEUTRAL instructions in this section.
ATLV 4300 330495 (10- -98)
CHASSIS
2-25