Parking Brake; Tires And Wheels; To Replace Front Tire And Wheel - Tennant ATLV 4300 Service Manual

CHASSIS

PARKING BRAKE

The parking brake is activated by a pedal located
above the service brake pedal. Pushing on the
parking brake will lock the service brake pedal in
position. To release the parking brake----press on
the service brake pedal.

TIRES AND WHEELS

The front and rear tires on the ATLVt 4300 are
pneumatic. The rims are one piece steel tubeless
style.
NOTE: Inflate the front tires to 22 psi and the rear
tires to (7 psi. standard, 18 psi. optional all terrain
tires).

TO REPLACE FRONT TIRE AND WHEEL

FOR SAFETY: Before Leaving Or
Servicing Machine; Stop On Level
Surface, Set Parking Brake, turn off
machine, and remove key.
1. Loosen the four wheel nuts before raising
the front end of the machine. DO NOT
remove the wheel nuts at this point.
2. Jack up the front of the machine at the
indicated jack points. Install jack stands
under the machine frame.
3. Finish removing the four wheel nuts.
Remove the tire and wheel assembly from
the machine.
4. Position the new tire and wheel assembly
onto the front axle hub.
5. Reinstall the four wheel nuts and tighten
finger tight.
6. Remove the jack stands and lower the
machine to the floor.
2-10
ATLV 4300 330495 (10- -98)