To Set Travel Speeds - Tennant ATLV 4300 Service Manual

CHASSIS

TO SET TRAVEL SPEEDS

FOR SAFETY: Before Leaving Or
Servicing Machine; Stop On Level
Surface, Set Parking Brake, turn off
machine, and remove key.
1. Go to the operators compartment and locate
the two hex screws and jam nuts at the front
and rear of the propel pedal.
2. Start with the bolt under the rear (heel)
portion of the propel pedal set at I--1/8 inch
from the top of the bolt head to the floor of
the operators compartment. This should give
about 4 mph.
3. Use the bolt under the front (toe) portion of
the propel pedal to set the maximum forward
speed to 16 mph.
4. Loosen the jam nut and screw the bolt up or
down to make any adjustments. Retighten
the jam nut after the speed adjustment has
been made.
2-26
ATLV 4300 330495 (10- -98)