Propel Cable; To Replace Propel Cable - Tennant ATLV 4300 Service Manual

CHASSIS

PROPEL CABLE

The model ATLVt 4300 is hydrostatically driven.
The foot pedal in the operators compartment is
connected to a push/pull cable that in turn is
connected to the propel pump arm.

TO REPLACE PROPEL CABLE

FOR SAFETY: Before Leaving Or
Servicing Machine; Stop On Level
Surface, Set Parking Brake, turn off
machine, and remove key.
1. Go under the machine at the front right
corner. Locate the propel cable ball joint on
the bottom of the propel pedal.
2. Remove the nyloc nut holding the ball joint
to the pedal. Pull the ball joint out of the
mount hole.
3. Loosen the large jam nuts on the propel
cable where it is attached to the machine
frame. Pull the cable out of the slot.
4. Follow the propel cable back and remove
any plastic ties that are holding the cable to
the frame or other cables.
5. Open the hopper cover and tilt the hopper
back.
6. Open the top engine cover.
7. Remove the five pan screws holding the rear
engine cover to the machine. Remove the
cover.
2-20
ATLV 4300 330495 (10- -98)