Engine Speeds - Tennant ATLV 4300 Service Manual

ENGINE- -DIESEL
21. Fill the engine with 5.2 L (5.5 qt) 10W30
SAE--CD/SE rated engine oil with a new
filter.
22. Reinstall the air cleaner mounting bracket to
the rear of the bellhousing. Tighten the two
M10 hex screws to 52 -- 67 Nm
(39 -- 51 ft lb).
23. Reinstall the two air cleaner tubes onto the
air cleaner and engine intake.
24. Reinstall the black cross brace running
between the legs of the roll bar.
25. Reinstall the engine cover prop rod brace.
26. Reinstall the engine cover and prop rod at
the hinges.
27. Reinstall both side fenders.
28. Reconnect the battery cables.
29. See TO ADJUST PROPEL NEUTRAL
instructions in the CHASSIS section of this
manual before attempting to start the
machine.
30. Start the machine. The engine speed and
travel speeds must be checked and set at
this point.. See below for engine speed
setting. See TO SET TRAVEL SPEEDS
instructions in the CHASSIS section.
31. After the engine and travel speeds have
been set, close the seat assembly and
reinstall the rear engine cover. Tilt the
hopper in place and operate the machine.
Check all systems carefully for proper
operation

ENGINE SPEEDS

The idle speed of the model ATLV 4300 is set at
the factory at 1200±50 rpm. The top engine speed
should not exceed 3050±50 rpm. To set the
engine speed, use the position of the end of the
throttle cable in the cable clamp on the engine
bracket to set the upper engine speed. Use the
stop bolt on the engine injector pump to set the
engine idle speed.
6-16 ATLV 4300 330495 (10- -98)