Configuring Session Manager
Command
verify [verbose]
Example:
switch(config-s)# verify
Committing a Session
Use the following command in session mode to commit a session:
Command
commit [verbose]
Example:
switch(config-s)# commit
Saving a Session
Use the following command in session mode to save a session:
Command
save location
Example:
switch(config-s)# save
bootflash:sessions/myACLs
Discarding a Session
Use the following command in session mode to discard a session:
Command
abort
Example:
switch(config-s)# abort
switch#
Verifying the Session Manager Configuration
To display the Session Manager configuration information, perform one of the following tasks:
Purpose
Verifies the configuration as a whole, based on the
existing hardware and software configuration and
resources. Cisco NX-OS returns an error if the
configuration does not pass this verification.
Purpose
Validates the configuration changes made in the
current session and applies valid changes to the
device. If the validation fails, Cisco NX-OS reverts
to the original configuration.
Purpose
(Optional) Saves the session to a file. The location
can be in bootflash:, slot0:, or volatile:.
Purpose
Discards the configuration session without applying
the changes.
Cisco Nexus 7000 Series NX-OS System Management Configuration Guide
Committing a Session
159