Cisco Nexus 7000 Series Configuration Manual page 432
Hide thumbs
Also See for Nexus 7000 Series:
- Command reference manual (1018 pages) ,
- Reference manual (746 pages) ,
- Configuration manual (536 pages)
Table of Contents
Advertisement
Configuration Examples for XMLIN
Lesser General Public License (LGPL) Version 2.1. A copy of each
such license is available at
http://www.opensource.org/licenses/gpl-2.0.php and
http://www.opensource.org/licenses/lgpl-2.1.php
switch(xmlin)# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)(xmlin)# interface ethernet 2/1
% Success
switch(config-if-verify)(xmlin)# cdp enable
% Success
switch(config-if-verify)(xmlin)# end
<?xml version="1.0"?>
<nf:rpc xmlns:nf="urn:ietf:params:xml:ns:netconf:base:1.0"
xmlns="http://www.cisco.com/nxos:6.2.2.:configure_"
xmlns:m="http://www.cisco.com/nxos:6.2.2.:_exec"
xmlns:m1="http://www.cisco.com/nxos:6.2.2.:configure__if-eth-base" message-id="1">
<nf:edit-config>
<nf:target>
<nf:running/>
</nf:target>
<nf:config>
<m:configure>
<m:terminal>
</nf:rpc>
]]>]]>
The following example shows how you must enter the end command to finish the current XML configuration
before you generate an XML instance for a show command.
switch(xmlin)# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)(xmlin)# interface ethernet 2/1
switch(config-if-verify)(xmlin)# show interface ethernet 2/1
********************************************************
Please type "end" to finish and output the current XML document before building a new one.
********************************************************
% Command not successful
switch(config-if-verify)(xmlin)# end
<?xml version="1.0"?>
<nf:rpc xmlns:nf="urn:ietf:params:xml:ns:netconf:base:1.0"
xmlns="http://www.cisco.com/nxos:6.2.2.:configure_"
xmlns:m="http://www.cisco.com/nxos:6.2.2.:_exec" message-id="1">
<nf:edit-config>
<nf:target>
</nf:target>
<nf:config>
</nf:edit-config>
Cisco Nexus 7000 Series NX-OS System Management Configuration Guide
404
<interface>
<__XML__PARAM__interface>
<__XML__value>Ethernet2/1</__XML__value>
<m1:cdp>
<m1:enable/>
</m1:cdp>
</__XML__PARAM__interface>
</interface>
</m:terminal>
</m:configure>
</nf:config>
</nf:edit-config>
<nf:running/>
<m:configure>
<m:terminal>
<interface>
<__XML__PARAM__interface>
<__XML__value>Ethernet2/1</__XML__value>
</__XML__PARAM__interface>
</interface>
</m:terminal>
</m:configure>
</nf:config>
Converting CLI Commands to Network Configuration Format
Advertisement
Table of Contents
