Default Settings For Rollbacks; Configuring Rollbacks; Creating A Checkpoint - Cisco Nexus 7000 Series Configuration Manual

Configuring Rollback

Default Settings for Rollbacks

This table lists the default settings for rollback parameters.
Parameters
Rollback type

Configuring Rollbacks

Be aware that the Cisco NX-OS commands may differ from the Cisco IOS commands.
Note

Creating a Checkpoint

You can create up to ten checkpoints of your configuration.
Procedure
Step 1
switch interfaces that are a part of the BFD sessions are powered up. To resolve this issue, shut
down all the interfaces that are a part of the BFD sessions using the shutdown command before
executing the bfd hw-offload-module command or the no form of this command.
• When an FEX is being configured while a rollback vPC is applied to an interface, the FEX goes
offline momentarily. When this occurs, rollback does not wait for the FEX to come online, and
executes the configuration commands for the interface, resulting in failure because the corresponding
FEX is not yet provisioned. To resolve this issue, manually execute the FEX-related configuration
commands after the FEX is online.
Command or Action
[no] checkpoint {[cp-name]
[description descr] | file file-name
}
Example:
switch# checkpoint stable
Cisco Nexus 7000 Series NX-OS System Management Configuration Guide
Default
Atomic
Purpose
Creates a checkpoint of the running configuration to either a
user checkpoint name or a file. The checkpoint name can be any
alphanumeric string up to 80 characters but cannot contain
spaces. If you do not provide a name, Cisco NX-OS sets the
checkpoint name to user-checkpoint-number where number is
from 1 to 10.
The description can contain up to 80 alphanumeric characters,
including spaces.
You can use the no form of the checkpoint command to remove
a checkpoint name. Use the delete command to remove a
checkpoint file.
Default Settings for Rollbacks
151