Default Settings For Lldp - Cisco Nexus 7000 Series Configuration Manual

Default Settings for LLDP

• Beginning with Cisco NX-OS Release 5.2, LLDP is supported for the Cisco Nexus 2000 Series Fabric
Default Settings for LLDP
This table lists the LLDP default settings.
Parameters
Global LLDP
LLDP on interfaces
LLDP hold time (before discarding)
LLDP reinitialization delay
LLDP timer (packet update frequency)
LLDP TLVs
LLDP receive
LLDP transmit
DCBXP
Configuring LLDP
Note Cisco NX-OS commands for this feature may differ from Cisco IOS commands for a similar feature.
Enabling or Disabling LLDP Globally
You can enable or disable LLDP globally on a device. You must enable LLDP globally to allow a device to
send and receive LLDP packets.
Cisco Nexus 7000 Series NX-OS System Management Configuration Guide
362
Extender. LLDP packets can now be sent and received through the Fabric Extender ports for neighbor
discovery.
◦ All LLDP configuration on Fabric Extender ports occurs on the supervisor. LLDP configuration
and show commands are not visible on the Fabric Extender console.
◦ LLDP is not supported for a Fabric Extender-virtual port channel (vPC) connection.
Default
Disabled
Enabled, after LLDP is enabled globally
120 seconds
2 seconds
30 seconds
Enabled
Enabled, after LLDP is enabled globally
Enabled, after LLDP is enabled globally
Enabled, provided LLDP is enabled
Configuring LLDP