Cisco Nexus 7000 Series Configuration Manual page 377
Hide thumbs
Also See for Nexus 7000 Series:
- Command reference manual (1018 pages) ,
- Reference manual (746 pages) ,
- Configuration manual (536 pages)
Table of Contents
Advertisement
Configuring ERSPAN
Step 10
Step 11
Step 12
Command or Action
ipv4 | ipv6]] [pc-lane
port-number] [src_mac
mac-address] [trace-route [true
| false]]
switch(config-erspan-src)# [no]
filter frame-type eth
switch(config-erspan-src)# [no]
filter frame-type arp [[arp-rarp
[arp | rarp]] [req-resp [req |
rsp]] [sender-ip ip-address]
[target-ip ip-address]]
switch(config-erspan-src)# [no]
filter frame-type fcoe [[fc-sid
FC-source-ID] [fc-did
FC-dest-ID] [fcoe-type
fcoe-value] [r-ctl r-ctl-value] [sof
sof-value] [cmd-code cmd-value]]
Cisco Nexus 7000 Series NX-OS System Management Configuration Guide
Purpose
• bpdu—Specifies a filter based on the bridge protocol data
unit (BPDU) class of packets.
• cos—Specifies a filter based on the class of service (CoS)
in the dotlq header.
• dest-mac—Specifies a filter based on a destination MAC
address.
• eth-type—Specifies a filter based on the Ethernet type.
• flow-hash—Specifies a filter based on the result bundle
hash (RBH) value.
• frame-type—Specifies a filter based on a frame type.
• pc-lane—Specifies a filter based on a member of the port
channel.
• src-mac—Specifies a filter based on a source MAC
address.
• trace-route—Specifies a filter based on the route bit in
the header.
(Optional)
Configures the Ethernet frame type filter for the ERSPAN
session. To remove the filter from the session, enter the no form
of the command.
(Optional)
Configures the ARP frame type filter for the ERSPAN session.
To remove the filter from the session, enter the no form of the
command.
• arp-rarp—Specifies an ARP or RARP frame type filter.
• req-resp—Specifies a filter based on a request or response.
• sender-ip—Specifies a filter based on a sender IP address.
• target-ip—Specifies a filter based on a target IP address.
(Optional)
Configures the FCoE frame type filter for the ERSPAN session.
To remove the filter from the session, enter the no form of the
command. The optional keywords are as follows:
• fc-sid—Specifies a filter based on an FC source ID.
• fc-did—Specifies a filter based on an FC destination ID.
• fcoe-type—Specifies a filter based on an FCoE type.
Configuring Rule-Based ERSPAN
349
Advertisement
Table of Contents
