Discarding A Cfs Configuration; Disabling Cfs Distribution Globally - Cisco Nexus 7000 Series Configuration Manual

Discarding a CFS Configuration

Discarding a CFS Configuration
You can discard configuration changes and release the lock.
If you discard configuration changes, the application flushes the pending database and releases locks in
Caution
the fabric.
Procedure
Step 1
Step 2
Step 3
switch# configure terminal
switch(config)# ntp abort
This will prevent CFS from distributing the configuration to other switches.
Are you sure? (y/n) [n] y
switch(config)# show ntp session status
Last Action Time Stamp : Wed Aug 14 16:07:25 2013
Last Action : Abort
Last Action Result : Success
Last Action Failure Reason : none

Disabling CFS Distribution Globally

You can disable CFS distribution for a device, isolating the applications using CFS from fabric-wide
distributions while maintaining physical connectivity. When CFS is globally disabled on a device, CFS
operations are restricted to the device, and all CFS commands continue to function as if the device was
physically isolated.
Before You Begin
If the virtual port channel (vPC) feature is enabled, only IP distribution is disabled. You must first disable
vPC before you can disable CFS distribution.
Cisco Nexus 7000 Series NX-OS System Management Configuration Guide
40
Command or Action
switch# configure terminal
switch(config)# application-name
abort
switch(config)# show
application-name session status
Purpose
Enters global configuration mode.
Aborts the application configuration, discards the
configuration changes, closes the CFS session, and
releases the fabric lock.
Note The abort command is supported only on the
device where the fabric lock is acquired.
(Optional)
For the specified application, displays the CFS session
status.
Configuring CFS