Default Settings For Cdp; Configuring Cdp; Enabling Or Disabling Cdp Globally - Cisco Nexus 7000 Series Configuration Manual

Default Settings for CDP

Default Settings for CDP
This table lists the default settings for CDP parameters.
Parameters
CDP
CDP version
CDP device ID
CDP timer
CDP hold timer

Configuring CDP

Be aware that the Cisco NX-OS commands for this feature may differ from those commands used in Cisco
Note
IOS.

Enabling or Disabling CDP Globally

CDP is enabled by default. You can disable CDP and then reenable it.
You must enable CDP on the device before you enable CDP on any interfaces. If CDP is disabled globally
and you enable CDP on specified interfaces, CDP will not be active on those interfaces; the system does not
return an error message.
Procedure
Step 1
Step 2
Cisco Nexus 7000 Series NX-OS System Management Configuration Guide
86
Command or Action
configure terminal
Example:
switch# configure terminal
switch(config)#
[no] cdp enable
Example:
switch(config)# cdp enable
Default
Enabled globally and on all interfaces
Version 2
Serial number
60 seconds
180 seconds
Purpose
Enters global configuration mode.
Enables or disables the CDP feature on the
entire device. It is enabled by default.
Configuring CDP