Related Documents; Feature History For Eem - Cisco Nexus 7000 Series Configuration Manual

Related Documents

action 1 cli conf t
action 2 cli int et1/1
action 3 cli no shut
This example creates an EEM policy that allows the CLI command to execute but triggers an SNMP notification
when a user enters configuration mode on the device:
event manager applet TEST
event cli match "conf t"
action 1.0 snmp-trap strdata "Configuration change"
action 2.0 event-default
You must add the event-default action statement to the EEM policy or EEM will not allow the CLI
Note
command to execute.
This example shows how to correlate multiple events in an EEM policy and execute the policy based on a
combination of the event triggers. In this example, the EEM policy is triggered if one of the specified syslog
patterns occurs within 120 seconds.
event manager applet eem-correlate
event syslog tag one pattern "copy bootflash:.* running-config.*"
event syslog tag two pattern "copy run start"
event syslog tag three pattern "hello"
tag one or two or three happens 1 in 120
action 1.0 reload module 1
Note For additional EEM configuration examples, see
Configuration Examples, on page
Related Documents
Related Topic
EEM commands
VDCs

Feature History for EEM

The table below summarizes the new and changed features for this document and shows the releases in which
each feature is supported. Your software release might not support all the features in this document. For the
latest caveats and feature information, see the Bug Search Tool at
release notes for your software release.
Cisco Nexus 7000 Series NX-OS System Management Configuration Guide
268
Embedded Event Manager System Events and
409.
Document Title
Cisco Nexus 7000 Series NX-OS System Management
Command Reference
Cisco Nexus 7000 Series NX-OS Virtual Device
Context Configuration Guide
Configuring the Embedded Event Manager
https://tools.cisco.com/bugsearch/ and the