Cisco Nexus 7000 Series Configuration Manual page 346

Configuring Exception SPAN
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
Cisco Nexus 7000 Series NX-OS System Management Configuration Guide
318
Command or Action
mode extended
Example:
switch(config-monitor)# mode
extended
[source
exception{layer3|fabricpath|other |
all}
Example:
switch(config-monitor)# filter
frame-type eth
destination interface type [ number
|range}
Example:
switch(config-monitor)#
destination
interface ethernet 2/5, ethernet
3/7
no shut
Example:
switch(config)# no shut
show monitor session
session-number
Example:
switch(config)# show monitor
session 3
copy running-config startup-config
Example:
switch(config)# copy
running-config startup-config
Purpose
(Optional)
(Optional) Configures the SPAN session as an extended
bidirectional session form of the command.
(Optional)
Configures the source as an exception SPAN session. These
exception types are supported:
• layer3—Specifies the Layer 3 exception type.
• fabricpath—Specifies the FabricPath exception type.
• other—Specifies other exceptions that are dropped
through redirect registers programmed with a drop
destination interface.
• all—Includes all Layer 3, FabricPath, and other
exceptions.
Configures destinations for copied source packets. You can
configure one or more destinations as either a series of
comma-separated entries or a range of numbers. You can
specify up to 128 interfaces.
SPAN destination ports must be either access or
Note
trunk ports.
The Cisco Nexus 2000 Series Fabric Extender
Note
interfaces and the fabric port channels connected
to the FEX cannot be configured as SPAN
destinations.
Enables the SPAN session. By default, the session is created
in the shut state.
(Optional) Displays the status of SPAN sessions, including
the configuration status of the rate limit, the percentage of
the maximum SPAN rate allowed per session, and the
modules on which the rate limit is and is not supported.
(Optional)
Copies the running configuration to the startup
configuration.
Configuring SPAN