Emerson Rosemount 5900S Series Reference Manual page 236

Rosemount 5900S Series
C-12
16 LEVEL
17 LENGTH_UNIT
18 LEVEL_RATE
19 LEVEL_RATE_UNIT
20 ENV_DEVICE_MODE
21 DIAGN_DEVICE_ALERT
22 DEVICE_VERSION_NUMBER
23 DIAGN_REVISION
24 SERIAL_NO
25 STATS_ATTEMPTS
26 STATS_FAILURES
27 STATS_TIMEOUTS
28 FF_DEVICE_NUMBER
29 FF_WRITE_PROTECT
30 P1451_SLAVE_STATS
31 P1451_HOST_STATS
32 DISTANCE
33 SIGNAL_STRENGTH
34 SIGNAL_STRENGTH_UNI
35 ANTENNA_TYPE
36 TCL
37 PIPE_DIAMETER
38 HOLD_OFF_DIST
39 ANTENNA_SIZE
40 OFFSET_DIST_G
41 TANK_HEIGHT_R
42 BOTTOM_OFFSET_DIST_C
43 CALIBRATION_DIST
44 TANK_SHAPE
Distance from the zero level (tank bottom) to the
product surface
Length Unit
Velocity at which the product surface is moving
Level Rate Unit
Service Mode (see Table C-5)
Errors and warnings for 2410 Tank Hub usage.
See Table C-14 on page C-16.
PM card SW version number
PM revision
Main Label Device ID
Total number of messages sent to PM
Total number of failed messages to PM
Total number of timed-out messages to PM
CM board serial number
CM board write protection status
Communication statistics
Communication statistics
Distance from the tank reference point (normally
the lower side of the flange) to the product
surface
Amplitude of the echo from the product surface.
A high value indicates a good reflection by the
surface
Signal strength unit
Antenna type on the device (see Table C-6)
Tank Connection Length. Electrical distance
between the transmitter's reference point and the
microwave unit. Only for user defined antennas.
Still-pipe inner diameter, see "Tank Geometry" on
page 4-6.
Hold Off Distance defines how close to the
gauge's reference point a level measurement is
accepted, see "Tank Geometry" on page 4-6.
Still-pipe Array antenna size
Gauge Reference Distance (G), see "Tank
Geometry" on page 4-6. Use the Distance Offset
(G) if a reference point other than the lower side
of the device flange is required.
Tank Reference Height (R) is defined as the
distance between the upper reference point and
the lower reference point (zero level). See "Tank
Geometry" on page 4-6.
Minimum Level Offset (C) defines a lower null
zone which extends the measurement range
beyond the Zero Level Reference Point down to
the tank bottom. See "Tank Geometry" on
page 4-6.
Calibration Distance is by default set to zero. It is
used to adjust the level measurement so that
measured levels match hand dipped levels. See
"Tank Geometry" on page 4-6.
Tank Type (see "Tank Shape" on page 4-15 and
Table C-8). Optimizes the 5900S for various tank
geometries.
Appendix C. F
OUNDATION
Reference Manual
00809-0100-5900, Rev CA
June 2014
Fieldbus Block Information