Emerson Rosemount 5900S Series Reference Manual page 67

Reference Manual
00809-0100-5900, Rev CA
June 2014
Pressure transmitter
Four M10 screws
Bracket
Groove
Mark
Flange
Ball valve
Adapter
Holes for
guide pins
Pressure
transmitter
Bracket for Bracket for
pressure pressure
transmitter transmitter
Still-pipe
Section 3. Installation
Mark
Nut
Verification Pin
11. Put the adapter on the flange.
12. Ensure that the mark on top of the
13. Mount the bracket and the pressure
Adapter
14. Tighten the four M10 screws with
Entry for
15. Connect the pipe at the pressure
pressure
transmitter
Closing
16. Put the 5900S radar gauge on the
5900S level
gauge
Adapter
17. Tighten the nut that connects the
Rosemount 5900S Series
Ensure that the guide pins on the
flange fit the holes at the bottom of the
adapter.
adapter aligns with the mark on the
closing.
transmitter.
washers.
transmitter input to the entry on the
flange and tighten the nut.
adapter. Ensure that the guide pin
inside the waveguide of the 5900S fits
the groove on the adapter.
Note! The adapter has two grooves.
Use the one that allows the transmitter
head to be aligned with the Verification
Pin as illustrated below in step 18.
The direction of the Verification Pin is
indicated by marks on the still-pipe
flange and the closing. See "LPG/LNG
Antenna Requirements" on page 3-13
for more information.
(The second groove on the adapter is
used for measurement verification
when replacing a TankRadar Rex level
gauge with a Raptor 5900S).
transmitter head to the adapter.
3-39