Service; Viewing Input And Holding Registers - Emerson Rosemount 5900S Series Reference Manual

Rosemount 5900S Series

6.2 SERVICE

6.2.1 Viewing Input
and Holding
Registers
6-2
This section briefly describes functions which may be useful for service and
maintenance of a Rosemount 5900S Radar Level Gauge. If not otherwise
stated, most examples are based on using the TankMaster WinSetup tool to
access these functions. See the Raptor System Configuration Manual
(Document No. 300510EN) for more information on how to use the
TankMaster WinSetup program.
Measured data is continuously stored in Input Registers of the Rosemount
5900S Radar Level Gauge. By viewing the Input registers you can check that
the device is working properly.
The Holding Registers store various parameters which are used to configure
the Rosemount 5900S Radar Level Gauge for various applications.
By using the Rosemount TankMaster WinSetup program, Holding Registers
can be edited simply by typing a new value in the appropriate value input field.
Some Holding Registers can be edited in a separate window. In this case
individual data bits can be changed.
To view input or holding registers of a 5900S do the following:
1. Start the TankMaster WinSetup program.
2. In the TankMaster WinSetup workspace window select the Rosemount
5900S Radar Level Gauge:
3. Click the right mouse button and choose the View Input/View Holding
Registers option, or from the Service menu choose Devices>View
Input/View Holding Registers.
Reference Manual
00809-0100-5900, Rev CA
Section 6. Service and Troubleshooting
June 2014