Example Of Byte Write Operation In Self Programming Mode - NEC 78K0S/KB1+ User Manual

19.8.8 Example of byte write operation in self programming mode

An example of the byte write operation in self programming mode is explained below.
<1> Set 05H (byte write) to the flash program command register (FLCMD).
<2> Set the number of block to which data is to be written, to flash address pointer H (FLAPH).
<3> Set the address at which data is to be written, to flash address pointer L (FLAPL).
<4> Set the data to be written, to the flash write buffer register (FLW).
<5> Clear the flash status register (PFS).
<6> Write ACH to the watchdog timer enable register (WDTE) (clear and restart the watchdog timer counter)
<7> Execute the HALT instruction then start self programming. (Execute an instruction immediately after the
HALT instruction if self programming has been executed.)
<8> Check if a self programming error has occurred using bit 1 (VCERR) and bit 2 (WEPRERR) of PFS.
Abnormal → <9>
→ <10>
Normal
<9> Byte write processing is abnormally terminated.
<10> Byte write processing is normally terminated.
Note This setting is not required when the watchdog timer is not used.
Caution If a write results in failure, erase the block once and write to it again.
CHAPTER 19 FLASH MEMORY
User's Manual U17446EJ3V1UD
Note
.
303