Table of Contents
Advertisement
CHAPTER 12 8-BIT A/D CONVERTER ( µ PD780344, 780344Y SUBSERIES)
12.4.3 8-bit A/D converter operation mode
Select one analog input channel from among ANI0 to ANI7 using analog input channel specification register 0
(ADS0) to start A/D conversion.
A/D conversion can be started in either of the following two ways.
• Hardware start: Conversion is started by trigger input (rising edge, falling edge, or both rising and falling edges
specified).
• Software start:
Conversion is started by specifying A/D converter mode register 0 (ADM0).
The A/D conversion result is stored in A/D conversion result register 1 (ADCR1), and the interrupt request signal
(INTAD0) is simultaneously generated.
(1) A/D conversion by hardware start
When bit 6 (TRG0) and bit 7 (ADCS0) of A/D converter mode register 0 (ADM0) are set to 1 after bit 0 (ADCE0)
is set to 1, the A/D conversion standby state is set. When the external trigger signal (ADTRG) is input, A/D
conversion of the voltage applied to the analog input pins specified by analog input channel specification register
0 (ADS0) starts.
Upon the end of the A/D conversion, the conversion result is stored in A/D conversion result register 1 (ADCR1),
and the interrupt request signal (INTAD0) is generated. After one A/D conversion operation is started and ended,
the next conversion operation is not started until a new external trigger signal is input.
If ADS0 is rewritten during A/D conversion, the converter suspends A/D conversion and waits for a new external
trigger signal to be input. When the external trigger input signal is reinput, A/D conversion is carried out from
the beginning. If ADS0 is rewritten during A/D conversion wait, A/D conversion starts when the following external
trigger input signal is input.
If ADCS0 is set to 0 during A/D conversion, the A/D conversion operation stops immediately.
Caution When P03/INTP3/ADTRG is used as the external trigger input (ADTRG), specify the valid edge
by bits 1 and 2 (EGA00, EGA01) of A/D converter mode register 0 (ADM0) and set the interrupt
mask flag (PMK3) to 1.
User's Manual U15798EJ2V0UD
233
Advertisement
Table of Contents
