Sample Network And Initial Configuration Script (Secondary Ums Server) - 3Com VCX V7000 Installation And Maintenance Manual

Sample Network and
Initial Configuration
Script (Secondary
UMS Server)
Configure networking now? [yes] :
---------- Configuring Hostname ----------
Enter system hostname [localhost] : vcxums02
---------- Configuring IP Interface 'eth0' ----------
Enter IP Address
Enter Network Subnet Mask
Enter Default Gateway Address
---------- Configuring IP Interface 'eth1' ----------
Enter IP Address
Enter Network Subnet Mask
Enter Default Gateway Address
---------- Configuring DNS Servers ----------
Enter DNS servers one at a time.
When done, enter 0.0.0.0 to stop.
Primary DNS Server
Secondary DNS Server [192.168.1.2] : 10.26.10.31
Tertiary DNS Server
Configuring the Firewall
After you have finished the UMS installation script, configure the VCX
firewall to pass UMS packets using these commands.
modfw -p ums allow 10.20.30.40
modfw -p ums allow 10.20.30.41
modfw -p ums allow 10.20.30.42
modfw -p ums allow 10.20.30.43
Each command allows ums-related traffic from Primary or Secondary VCX
servers.
This section contains a sample of the network and initial configuration
script that runs when the system is first started. The script displays the
current network settings and then asks you if you want to accept the
current networking parameters or configure them. Sample answers,
appropriate for the secondary server, are provided in bold type along with
explanations of those answers. Explanations are in italics.
Network Configuration Script — Secondary UMS Server
Press the Enter or Return key to accept yes as the suggested answer.
[192.168.1.100
[255.255.255.0
[192.168.1.254
[192.168.1.100
[255.255.255.0
[192.168.1.254
[192.168.1.1] : 10.25.10.31
[0.0.0.0] : 0.0.0.0
] : 10.20.30.46
] : 255.255.255.0
] : 10.20.30.254
] : 10.20.30.47
] : 255.255.255.0
] : 10.20.30.254
Installation Scripts 79