3Com VCX V7000 Installation And Maintenance Manual page 135

Replacing a Call Processor Server Disk in a Four-Server Configuration
Set Up Oracle Database Replication
1 On the running server, log in as cworks.
2 Enter these commands:
cd /opt/3com/VCX/auth/bin
./setupReplication
If you see any error messages when you run the setupReplication script,
drop replication (see
procedure) and run the setupReplication script again.
The script asks for the IP addresses of the two servers and then checks the
replication state of the authentication databases on them. After the
check, database replication begins.
Check for Oracle Database Replication to Complete
To check the database replication:
1 Log in as cworks.
2 Enter these commands:
cd /opt/3com/VCX/auth/bin
./checkReplication
The script asks for the IP addresses of the two servers and then checks the
replication state of the authentication databases and reports the status.
When replication has been completed, you see this message:
INFO: Multi-Master Replication STATUS:
**************************************
*************** NORMAL ***************
**************************************
On the primary server, restart all VCX services.
1 Log in as root.
2 Enter these commands:
cd /etc/rc.d/rc3.d
./S99vcx start
On the secondary server, restart all VCX services.
1 Log in as root.
"Drop Database Replication"
135
earlier in this