Sample Ums Installation Script (Primary Server) - 3Com VCX V7000 Installation And Maintenance Manual

Sample UMS
Installation Script
(Primary Server)
Type of VCX 7300 Installation (S-Standalone/C-Client/V-Server)? [S]
Number of voip ports? [144]
IP address of the outbound proxy? [10.20.30.41]
Name of the SIP DDD?
TCP/UDP Port on which the VCX 7300 will receive SIP messages [5060] 5060
IP address of the secondary proxy? (hit Enter if none) [ ] 10.20.30.43
Intelligent Mirroring configurations
Should Intelligent Mirroring be enabled (Y/N)?
Enter the Device Name of the Network Card to be used by UMS?
Enter the Device Name of the Second Network Card to be used by UMS, press ENTER if
only one? :
Name of the Remote Intelligent Mirrored system? [ ] vcx02
After the network and initial installation script has been completed, the
UMS installation script starts.
Press the Enter or Return key to accept S as the suggested answer.
Press the Enter or Return key to accept the default number (144) of VOIP
ports that the system will support. Do not enter a different value without
consulting 3Com.
Outbound Proxy is another name for the Call Processor. Enter the IP
address of the primary VCX Call Processor.
[10.20.30.41]
The SIP Default Dialing Domain software runs on the same server as the
VCX Call Processor. Press the Enter or Return key to accept the IP address
of the primary VCX Call Processor.
The VCX Call Processor and UMS both use the same port number but on
different IP addresses.
Enter the IP address of the secondary VCX Call Processor server
(10.20.30.43 in this sample configuration that contains a single pair of
servers).
All supported UMS configurations require Intelligent Mirroring. Enter y.
Press the Enter or Return key to indicate that UMS uses only the eth0
network card.
Enter the name of the standby UMS server (vcx02 in this example).
UMS Installation Script — Primary Server
[N]: y
:eth0
Installation Scripts 39