3Com VCX V7000 Installation And Maintenance Manual page 91

3 Press the Select button, located in the center of the four arrow buttons.
4 Press 5 (Set NCP IP).
5 Enter the IP address of the primary VCX Call Processor.
VCX systems typically have two Call Processor servers. One is the primary
server and the other is the alternate server, which is available for fail-over
purposes.
6 Press # to save the new setting.
7 Press the Select button.
8 Press 6 (VCX Cnfig Menu).
9 Press 1 (Alt Dnld Dervr).
10 Enter the IP address of the Alternate Call Processor Server.
11 Press # to save the new setting.
12 Connect the Ethernet data cable to the telephone.
13 Disconnect and reconnect the telephone power cord.
The telephone:
Obtains an IP address from a DHCP in your network.
■
Contacts the primary Call Processor server and begins to download
■
the appropriate software.
During the downloading process, several progress messages appear in
the telephone display panel. After the software has been downloaded to
the telephone, the message "Local Phone Number:" appears.
To log in on the telephone, a user enters:
An extension number, followed by #
■
A numeric password, followed by #
■
To assign a telephone extension to a user, you must configure the
telephone extension number and user ID using the VCX Administrator
User Interface. For information about how to perform these tasks, refer
to the VCX Administration Guide.
Telephone Installation 91