3Com VCX V7000 Installation And Maintenance Manual page 72

72 C 3: I
HAPTER NSTALLATION
n
Please choose from the following network interfaces to configure
your SIP downloader:
eth0 eth1
enter interface name > eth1
Is the IP Address for eth1 10.20.30.41? [y]:
Initial VCX configuration completed successfully.
S T S
CRIPTS FOR WO ERVER
If you want to enter a range of trusted end point IP addresses, refer to
Appendix C, "Specifying a Range of Trusted End
in this chapter, trusted end points are specified by entering individual IP
addresses.
End of Initial VCX Configuration Script — Secondary VCX Server
Modifying the Hosts File (Secondary VCX Server)
You must modify the /etc/hosts file on the secondary VCX server to add
an alias for the UMS server.
1 Use the nano or vi editor to open the file.
2 Remove umshost from the line that contains it.
3 Add this line:
10.20.30.44 umshost
4 Save the file and exit.
Enabling Database Replication Between VCX Servers
To enable database replication between the primary and secondary VCX
servers, configure both servers to the point described in
Hosts File (Primary VCX Server)"
(Secondary VCX Server)", earlier in this chapter.
To enable database replication, follow these steps:
1 Stop the auth application on both servers.
On the primary VCX server and the secondary VCX server enter these
commands:
cd /opt/3com/VCX/auth/bin
./auth stop
2 Stop the dir application on both servers.
On the primary VCX server and the secondary VCX server enter these
commands:
P
AIRS
and "Modifying the Hosts File
Points". In the examples
"Modifying the