3Com VCX V7000 Installation And Maintenance Manual page 105

To set the VLAN ID number for a 3105 Attendant Console:
1 Plug a standard Ethernet cable into the data port, located on the
underside of the Attendant Console.
2 Plug the other end of the Ethernet cable into an active network jack.
3 Using an adapter (female 9-pin DB9 to female RJ-45) and a standard
Ethernet cable, connect a serial port on your PC to the serial port on the
underside of the 3105 Attendant Console.
4 Connect a 3Com power adapter to an AC power outlet.
5 Connect the other end of the power adapter cable to the power
connector on the underside of the 3105 Attendant Console.
6 Use a terminal emulation program such as Hyperterm to connect to the
serial port on your PC. The configuration is:
9600 baud
■
8 data bits
■
1 stop bit
■
No parity
■
No flow control
■
7 In the Hyperterm window, enter this command, substituting the one- or
two-digit VLAN ID number for XY:
VcxSetVlanConfig XY
V7111 and V7122 Gateways
You cannot configure V7111 or V7122 gateways to operate on a VLAN.
VLAN Configuration 105