3Com VCX V7000 Installation And Maintenance Manual page 96

96 C 5: I
HAPTER NSTALLING
D
EVICES
10 Enter the IP address of the Alternate Call Processor Server.
11 Press # to save the new setting.
12 Connect the Ethernet data cable to the telephone.
13 Disconnect and reconnect the telephone power cord.
The telephone:
Obtains an IP address from a DHCP in your network.
■
Contacts the primary Call Processor server and begins to download
■
the appropriate software.
During the downloading process, several progress messages appear in
the telephone display panel. After the software has been downloaded to
the telephone, the message "Local Phone Number:" appears.
To log in on the telephone, a user enters:
An extension number, followed by #
■
A numeric password, followed by #
■
To assign a telephone extension to a user, you must configure the
telephone extension number and user ID using the VCX Administrator
User Interface. For information about how to perform these tasks, refer
to the VCX Administration Guide.
Configuring the 3Com 3102 Telephone without a DHCP Server
If your network does not use a DHCP server to provide IP addresses to
devices, you must manually configure the IP address of the 3Com 3102
Business Telephone.
1 Configure the telephone as described in
Telephone with a DHCP Server"
disconnect and reconnect the power as described in the final step.
2 Press the Program button, located at the top of the row of buttons on the
right side of the telephone.
3 Press 2 (Set My IP).
4 Enter the IP address that you want to assign to the telephone.
5 Press # to save the new setting.
6 Press 3 (Set SubNMsk).
"Configuring the 3102
earlier in this section, but do not