Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable MLD Snooping function on VLAN 2:
T2500G-10TS(config)# ipv6 mld snooping vlan 2
32.11 ipv6 mld snooping vlan router-aging-time
Description
The ipv6 mld snooping vlan router-aging-time command is used to specify
router port aging time for a specified VLAN. If this time is set to 0, then the
global router port aging time will be used. The default time is 0. To restore the
default timer, please use no ipv6 mld snooping vlan router-aging-time
command.
Syntax
ipv6 mld snooping vlan
no ipv6 mld snooping vlan
Parameter
vlan-id
timer
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Specify the router port aging time as 100 seconds in VLAN 2:
T2500G-10TS(config)# ipv6 mld snooping vlan 2 router-aging-time 100
vlan-id
—— The specified IEEE 802.1Q VLAN ID, ranging from 1 to 4094.
—— Aging time of the router port in seconds, ranging from 0 to 1000.
router-aging-time
vlan-id
router-aging-time
273
timer