12.5
ip http secure-protocol
Description
The ip http secure-protocol command is used to configure the SSL protocol
version. To restore to the default SSL version, please use no ip http
secure-protocol command. By default, the switch supports SSLv3 and
TLSv1.
Syntax
ip http secure-protocol { [ ssl3 ] [ tls1 ] }
no ip http session
Parameter
ssl3 —— The SSL 3.0 protocol.
tls1 —— The TLS 1.0 protocol
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Configure the protocol of SSL connection as SSL 3.0:
T2500G-10TS(config)# ip http secure-protocol ssl3
12.6
ip http secure-ciphersuite
Description
The ip http secure-ciphersuite command is used to configure the
cipherSuites over the SSL connection supported by the switch. To restore to
the default ciphersuite types, please use no ip http secure-ciphersuite
command.
Syntax
ip http secure-ciphersuite { [ 3des-ede-cbc-sha ] [ rc4-128-md5 ]
[ rc4-128-sha ] [ des-cbc-sha ] }
no ip http secure-ciphersuite
86