Ip Dhcp Snooping Global - TP-Link T2500G-10TS Cli Reference Manual

13.4

ip dhcp snooping global

Description
The ip dhcp snooping global command is configure DHCP-Snooping
globally. To restore to the default value, please use no ip dhcp snooping
global command.
Syntax
ip dhcp snooping global [ global-rate
dec-threshold
no ip dhcp snooping global
Parameter
global-rate
messages that can be forwarded by the switch per second. The excessive
messages
(packet/second).By default, it is 0 standing for disable.
dec-threshold
Decline packets to trigger the Decline protection for the specific port. The
options are 0/5/10/15/20/25/30 (packet/second).By default, it is 0 standing
for disable.
dec-rate
the corresponding port will be limited to be this value if the transmission rate
of the Decline packets exceeds the Decline Threshold. The options are
5/10/15/20/25/30 (packet/second). By default, it is 5.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Configure the Global Flow Control as 30pps, the Decline Threshold as 20 pps,
and decline Flow Control as 20 pps for DHCP Snooping:
T2500G-10TS(config)# ip dhcp snooping global global-rate 30
dec-threshold 20 dec-rate 20
dec-rate
] [ dec-rate
—— The value to specify the maximum amount of DHCP
will be discarded.
——The value to specify the minimum transmission rate of the
——The value to specify the Decline Flow Control. The traffic flow of
95
global-rate
]
The options are
] [ dec-threshold
0/10/20/30/40/50