Ipv6 Mld Snooping Filter(Interface); Ipv6 Mld Snooping Filter-Mode - TP-Link T2500G-10TS Cli Reference Manual

Example
Create filter entry with filter ID as 2, start IP as ff80::1234 and end IP as
ff80::1235:
T2500G-10TS(config)# ipv6 mld snooping filter 2 ff80::1234 ff80::1235

32.21 ipv6 mld snooping filter(interface)

Description
The ipv6 mld snooping filter command is used to enable the filter function
on the interface. To disable the filter function, please use no ipv6 mld
snooping filter command.
Syntax
ipv6 mld snooping filter
no ipv6 mld snooping filter
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable filter function on interface gigabitEthernet 1/0/2:
T2500G-10TS(config)# interface gigabitEthernet 1/0/2
T2500G-10TS(config-if)# ipv6 mld snooping filter

32.22 ipv6 mld snooping filter-mode

Description
The ipv6 mld snooping filter-mode command is used to configure the filter
mode of the interface. The default mode is accept. To restore the default
mode, please use no ipv6 mld snooping filter-mode command.
Syntax
ipv6 mld snooping filter-mode {accept | refuse}
no ipv6 mld snooping filter-mode
280